Master Pneumatic – E100 Hydro-Jector 1/8 and 1/4

Discharge rate is 300 gallons (1135 liters) per hour at 100 psig (6.9 bar). Flushing action is instantaneous with minimal air loss compared to conventional drains.
HYDRO-JECTOR drains are available with 1/8 or 1/4 nipples. The 1/4 size is used with SERIES 380 and VANGUARD ﬁlters.
There is a manual override on the drain valve for clean-out and emergency use.
Inorder to install a hydro-jector on a VANGUARD or SERIES 380 ﬁlter you must order filter with the option designated “LDC”. This option removes the drain cock, and replaces it with a 1/4” threaded adapter. If ordering the units together the filter will automatically be an “LDC”.
The HYDRO-JECTOR is not recommended where heavy oil or foam is present, as can be the case in separators or large aftercoolers.

หมวดหมู่: Accessories, Brackets, Gauges and Valves, Combinations of Filters, Regulators, Lubricators and Valves, Drains and drain Tube-Away kit, FRL Heavy Industrial, Master Pneumatic ป้ายกำกับ: MASTER PNEUMATIC

คำอธิบาย

Master Pneumatic Thailand

E100 Hydro-Jector 1/8 and 1/4

HYDRO-JECTOR drains are for use with the SERIES 380 and VANGUARD ﬁlters wherever severe condensate problems exist. They can also be used to drain water separators, drain legs, and compressor receiver tanks. They operate with continuous, intermittent, or no air ﬂow, and drain only when liquids are present.

VANGUARD or SERIES 380 heavy-duty ﬁlters paired with HYDRO-JECTOR drains provide a low-cost, and effective means for draining water from a compressed air system before it can do harm. Smaller plants, those with 100 to 500 scfm compressors, will ﬁnd this an especially economical way to cope with the water problem.

To see a TYPICAL COMPRESSOR CIRCUIT EMPLOYING HYDRO-JECTOR DRAIN select the yellow tab Photos, click on sketch to enlarge.

SPEC

Drain Time	Adjustable 0.5 to 10 seconds.
Drain Interval	Adjustable 0.5 to 45 minutes.
Current Consumption	4 ma maximum.
Ambient Temperature	35° to 130°F (2° to 54°C).
Media Temperature	35° to 190°F (2° to 88°C).
Electrical Connection	DIN 43650A, ISO 440/6952.
Valve Type	2/2 direct acting, normally closed.
Valve Body	Forged brass; 3/16-inch (4.8 mm) oriﬁce.
Maximum Pressure	230 psig (16 bar).

DIMENSIONS

DOWNLOAD CATALOG (ดาวน์โหลดแคตตาล็อก)

	Master Pneumatic – E100 Hydro-Jector 1/8 and 1/4