Showing 204–210 of 300 results

  • 3/2 N.C. poppet valve for entering and exhausting the circuit
  • It allows to pneumatically supply the part of the system downstream of the valve
  • Opening and closing of the valve via solenoid operator
  • The supply pressure must be minimum 2 bars or higher
  • It is possible to produce the external supplied solenoid version by mounting the 305.10.05 between the valve main body and the solenoid pilot valve.
  • The air supply can only be done via port 1
  • Ensure that the downstream air consumption will not cause a pressure drop which could result in the pressure falling below the minimum operating values.
  • If the pressure inside the valve falls below 2 bars, the valve might shut off.
  • Atex certification (II 2GD o II 3GD) on request

  • Digital battery pressure gauge

  • Diaphragm pressure regulator with relieving
  • Available with 2 front outputs connections G1/8”
  • Available in four pressure ranges up to 12 bar
  • Ring nut for panel mounting
  • Available with integrated pressure gauge on the top of adjusting knob
  • Air supply can be applied by both directions (Right or Left)
  • Max. 6off pressure regulators in manifold configuration
  • Atex certification (II 2GD) on request

  • Panel-mounted digital pressure switch Series DS

  • Progressive start-up valve
  • Available in 4 sizes with flow rates up to 15000 Nl/min and connections from 1/8” to 1”
  • Suitable for downstream system gradual pressurization
  • Downstream circuit filling time regulated via a built in flow regulator
  • Full pressure is allowed once the down stream circuit pressure reaches 50% of the inlet pressure
  • Atex certification (II 2GD or II 3GD)

1700 STEEL LINE SERIES - SIZE 3

PNEUMAX – REGULATORS

  • Body, adjust. mechanism, AISI 316L stainless steel and caseback inter. components
  • AISI 316 Adjustment springs.
  • Fixing screws, adjustment screws and locknut in A4 (AISI 316) stainless steel.
  • Pressure regulator diaphragm with over-pressure exhaust (Relieving).
  • Low hysteresis rolling diaphragm.
  • Balanced system.

1700 STEEL LINE SERIES - SIZE 4

PNEUMAX – REGULATORS

  • Body, adjust. mechanism, AISI 316L stainless steel and caseback inter. components
  • AISI 316 Adjustment springs.
  • Fixing screws, adjustment screws and locknut in A4 (AISI 316) stainless steel.
  • Pressure regulator diaphragm with over-pressure exhaust (Relieving).
  • Low hysteresis rolling diaphragm.
  • Balanced system.